Chemical Engineering

Design of Tube and Shell Heat Exchanger for Fluids

Question Design task Design a tube and shell heat exchanger for the fluids and duty and complete Project Management tasks as detailed below. Design Assumptions: The overall ...

883 reads$18.50$11.00
Determine Degrees Of Freedom For Chemical Reactions

QuestionDetermine the number of degrees of freedom for the following system. (i) A gaseous mixture of N2, H2 with no catalyst present(ii) A gaseous mixture, initially of N2, H2 and...

1487 reads$2.00$1.00
Determine Numeric Solutions To Cubic Equations Of State

Question Develop a numeric solution to the following cubic equations of state (EoS). Ideal EoS van der Waals EoS Redlich-Kwong EoS Soave-Redlich-Kwong Peng-Robinson EoS ...

1949 reads$51.00$25.00
Determine the Volume of two CSTRs

Question There are 2 CSTRs in series. The conversion after the first reactor is 35% and after the second reactor is 72%. Given the following rate vs. conversion data, determine th...

1801 reads$2.75$1.50
Determining Liquid Flow Rate of SO2 Solution

Question Clean water is used to remove SO2 from air through a counter current scrubbing process to reach a 95% recovery, in which the flow rate of gas is 5000 std m3/h containing ...

837 reads$9.00$4.00
Determining Overall Mass Transfer Coefficient for Gas Phase

Question Water is used to absorb the vapor of methanol at 300 K and 101.325 kPa. The concentration of methanol in both gas and liquid phases are very low, with the equilibrium rel...

1473 reads$9.00$4.00
Difference between Emulsion and Suspension Polymerizations of Styrene

Question Heterogeneous PolymerisationThe emulsion and suspension polymerisations of styrene are useful for the formation of polystyrene latexes and foams.  Contrast the two s...

1295 reads$7.50$4.50
Difference Between Isothermal PFR Reaction and Isothermal CSTR Reaction

Question The elementary reaction A → B takes place in an isothermal PFR. When pure A is fed to the reactor at a flow rate of 10 mol/min with a concentration of 2.0 mol/L the ...

1036 reads$4.50$2.00
Cumene Synthesis from Benzene and Propylene Reaction

Question Cumene (MW = 120.19), used as an intermediary for a number of chemicals, is produced through the reaction of benzene (MW=78.11) and propylene (MW = 42.08) as shown below....

1721 reads$5.50$3.50
Compressibility Factor of Gas with Truncated Virial Equation

Question (A) Give the expression of the compressibility factor Z (Z = PV / RT) for a gas obeying the truncated virial equation of state: PV = RT + A2P, where A2 is a function of t...

2108 reads$8.00$5.00
Calculation Of R And Cv Of Gas

QuestionThe values of Cp and k for an ideal gas are 0.846 kJ/(kgK) and 1.289 respectively. What are the values of R and Cv for that gas? SummaryThe question belongs to Chemistry a...

969 reads$1.00$0.50
Calculation Of R And Cv Of Nitrogen Gas

QuestionWhat is the change in enthalpy and internal energy when nitrogen is heated from 300K to 400K? Assume that nitrogen behaves as an ideal gas, Cv is 0.743 kJ/(kgK) and Cp is 1...

843 reads$1.00$0.50